Español?

Cambiar el idioma al español?

Lams+

FOAM-SHARK™

Defoamer, Antifoam

AM-AG FOAM-SHARK™ is a water based, silicone emulsion, antifoam and defoamer. FOAM-SHARK™ can be used to prevent foam formation or knock down existing foam.

Use rates for FOAM-SHARK™ depends directly on temperature, composition, viscosity, agitation and other various conditions; therefore rates may require adjustment for the most effective dosage. Generally, use rates are lower when used as an antifoam to prevent or reduce foam formation.

PDFs:

 

Principal Functioning

Dimethylpolysiloxane10%
Constituents ineffective as a Spray Adjuvant 90%
——
100%

All ingredients are exempt from tolerance under 40 CFR 180.

SPECIALTY ADJUVANT SYSTEM DESIGNED FOR AGRICULTURE USE & NON-CROPLAND AREAS

Key Performance Components

• Water based silicon emulsion.

• Very quick foam knockdown.

• Easy to use formulation.

• Good at preventing foam before it starts.

Application Use Rate

(Per 100 Gallons)

Use FOAM-SHARK at 1/2 - 1 oz. per 100 gallons of Solution. It may be necessary to adjust the amount used according to individual conditions. In situations where foam develops after the uid level drops, stop agitation and add the recommended dosage of FOAM-SHARK. When foaming developsm in urea water solutions, it may be necessary to use as much as 2 ounces of FOAM-SHARK per 100 gallons of solution.

General Information

AM-AG FOAM-SHARK is a water based, silicone emulsion, antifoam and defoamer. FOAM-SHARK can be used to prevent foam formation or knock down existing foam. Use rates for FOAM-SHARK depends directly on temperature, composition, viscosity, agitation and other various conditions; therefore rates may require adjustment for the most eective dosage. Generally, use rates are lower when used as an antifoam to prevent or reduce foam formation.

Mixing Instructions

Prior to making any pesticide application, be sure to use clean mixing and application equipment. Carefully follow the observations on the productlabel. A jar test should be conducted for compatibility before mixing the individual components into the spray tank. Fill spray tank three - quarter fullwith water and begin agitation. Add FOAM-SHARK and continue the agitation process. Add pesticides and/or fertilizers as directed by theproduct label or use the following mixing order if no other instructions are available:

1. Micronutrients and fertilizers.

2. Dry flowables & water dispersible granules. ( Be sure the granules have dissolved well prior to adding the remainding ingredients ).

3. Water soluble pesticides.

4. Flowables & emulsiable concentrates.

5. Continue agitation and complete filling of the spray tank.